在温州酒店晚上怎么叫服务

Welcome to Xi'an Yunyi Pressure Gauge Factory website!

Set as home page | Add to collection | contact us

 contact number

Product navigation
Diaphragm pressure gauge series
Diaphragm pressure gauge series
Remote pressure gauge series
Remote transmission differential pressure gauge
Electric contact pressure gauge series
Bellows electric contact pressure gauge series
Stainless steel pressure gauge series
Differential pressure gauge series
Digital pressure gauge series
contact us

Xi'an Yunyi pressure gauge factory
Sales Department: 4000 118 588
Tel: 029-88643194
Fax: 029-88611928

Email: yunyi@369yb.com
Address: Lugang building, international harbor district, Xi'an City Precision pressure gauge

Product Q & A Your location: Home page Product Q & A >Text

What problems should be paid attention to when using precision pressure gauge

Author: admin Source: Release time: 2016-11-30 13:47:46 Number of hits:

In the verification and calibration of Bourdon tube pressure gauge, the standard gauge should select the multi division precision pressure gauge. The relative accuracy of this kind of meter is higher than that of direct reading type because the value of this kind of meter is verified by the method of fixed degree. We should also pay attention to the following points in use.

When the standard is not sealed, it can be used normally.

2. When using the precision pressure gauge, it should be used according to the value given in the verification certificate. For example, for a 0-1.0mpa precision pressure gauge, when the actual pressure value on the verification certificate is 0.1MPa, the indicated value is 29.8 grid. When the precision pressure gauge indicates 29.8 grid, it is the standard value of 0.1MPa. The pressure value not given in the certificate shall be calculated according to its linear data for comparison.

3. When tapping the displacement verification, only the tested meter should be knocked, not the precision pressure gauge. It should be regarded as a relative true value, and its error should not be considered.

4. When the precision pressure gauge is used to verify the working Bourdon tube pressure gauge, the absolute value of the basic error of the precision pressure gauge must be less than 1 / 3 of the absolute value of the basic error of the pressure gauge to be inspected. The measuring upper limit of the precision pressure gauge should exceed 75% of the upper limit of the tested pressure gauge.

5. There are many kinds of scale division number of precision pressure gauge, which is determined by the measuring range of pressure gauge, so there are as many as 120, 125, 160, 200, 250, 300, 320 and 400. It is difficult to convert the corresponding relationship between pressure and division. It is better to make the corresponding data of pressure and division into a comparison table, which is pasted on the pressure gauge or beside the working table, so as to facilitate the data comparison. When conditions permit, it is easy to find the software of pressure gauge and grid calculation on the Internet

If the rubber tube of the precision gauge is not tightly connected with the pressure gauge, it will cause the pressure signal of the precision gauge to drop off suddenly, or if the pressure gauge is not connected tightly, most of the pressure gauges will have low signal life In order to avoid the above problems, it can be protected by adding gas at the joint of the instrument.

Information Center Product Q & A Entering Yunyi contact us
Copyright: Xi'an Yunyi pressure gauge factory Shaan ICP Bei 12009609-1
National toll free telephone: 4000-118-588 Fax: 029-88611928
Direct: 029-88643194 88612256 email: yunyi@369yb.com
Address: Lugang building, international harbor district, Xi'an City Precision pressure gauge